Basic Chimney Service (Island)

1. Pre-Installation Services

• Site Assessment, Location Selection, Measurement Check

2. Unpacking and Inspection

• Careful Unboxing, Product Check, User Manual Review

3. Plumbing and Electrical Setup

• Water Inlet Connection, Drain Hose Placement, Power Supply Check, Voltage Stabilizer Setup (if required)

4. Leveling the Machine

• Position Adjustment, Vibration Minimization

5. Operational Testing

• First Run Test, Leak Detection, Error Code Check

6. User Orientation

• Usage Demonstration, Maintenance Tips, Troubleshooting Basics

7. Additional Services

• Accessory Installation, Old Appliance Removal, Custom Modifications

• Initial Inspection
  Power Supply Check, Compressor & Inverter Board Diagnosis, Cooling Performance Assessment

• Refrigerant & Cooling System Check
  Gas Level Inspection, Leak Detection, Condenser & Evaporator Coil Cleaning

• Inverter Compressor & PCB Repair
  Inverter Board Testing, Compressor Speed Adjustment, Faulty Component Replacement

• Thermostat & Temperature Control Repair
  Temperature Sensor Testing, Thermostat Calibration, Cooling Adjustment

• Defrosting & Drainage Check
  Ice Buildup Removal, Drain Pipe Cleaning, Auto-Defrost System Inspection

• Door & Seal Repair
  Gasket Condition Check, Door Alignment Adjustment, Air Leakage Fix

• Final Testing & Performance Review
  System Restart, Cooling Efficiency Check, Noise & Energy Consumption Assessment

• Additional Services
  Gas Refilling, Fan Motor Replacement, PCB Repair, Condenser & Evaporator Coil Repair

• Initial Inspection – Power Supply, Boot & Performance Check
• Screen & Display Repair – Flickering, Black Screen & Dead Pixel Fixing
• Keyboard & Touchpad Repair – Key Malfunction, Touchpad Sensitivity Fix
• Battery & Charging Issue Fix – Battery Replacement, Charging Port Repair
• Software & OS Troubleshooting – OS Installation, Driver Updates & Virus Removal
• Final Testing & Performance Check – Speed, Storage & System Stability Assessment

Split AC Installation Service by Repair Master

1. Pre-Installation Assessment

2. Proper Placement of Indoor and Outdoor Units

4. Vacuuming and Gas Charging

5. Performance Testing and Handover