Basic Chimney Service (Island)

1. Pre-Installation Services

• Site Assessment, Location Selection, Measurement Check

2. Unpacking and Inspection

• Careful Unboxing, Product Check, User Manual Review

3. Plumbing and Electrical Setup

• Water Inlet Connection, Drain Hose Placement, Power Supply Check, Voltage Stabilizer Setup (if required)

4. Leveling the Machine

• Position Adjustment, Vibration Minimization

5. Operational Testing

• First Run Test, Leak Detection, Error Code Check

6. User Orientation

• Usage Demonstration, Maintenance Tips, Troubleshooting Basics

7. Additional Services

• Accessory Installation, Old Appliance Removal, Custom Modifications

• Initial Inspection
  Power Supply Check, Compressor & Inverter Board Diagnosis, Cooling Performance Assessment

• Refrigerant & Cooling System Check
  Gas Level Inspection, Leak Detection, Condenser & Evaporator Coil Cleaning

• Inverter Compressor & PCB Repair
  Inverter Board Testing, Compressor Speed Adjustment, Faulty Component Replacement

• Thermostat & Temperature Control Repair
  Temperature Sensor Testing, Thermostat Calibration, Cooling Adjustment

• Defrosting & Drainage Check
  Ice Buildup Removal, Drain Pipe Cleaning, Auto-Defrost System Inspection

• Door & Seal Repair
  Gasket Condition Check, Door Alignment Adjustment, Air Leakage Fix

• Final Testing & Performance Review
  System Restart, Cooling Efficiency Check, Noise & Energy Consumption Assessment

• Additional Services
  Gas Refilling, Fan Motor Replacement, PCB Repair, Condenser & Evaporator Coil Repair

• Pre-Installation Check – Water Quality & Pressure Assessment, Suitable Location Selection
• Unboxing & Inspection – Product Verification, Accessories & Filter Check
• Water Inlet & Outlet Connection – Pipe Fitting, Leak-Proof Setup
• Filter & Membrane Installation – RO/UV/UF Filter Setup, Proper Alignment
• System Flushing & Testing – Initial Water Flow Check, Leak Detection
• Final Performance Check – Purification Quality Test, Flow Rate Assessment

• Pre-Installation Services Site Assessment, Measurement Check, Window Frame Inspection
• Unpacking and Inspection Careful Unboxing, Product Check, User Manual Review
• Electrical and Structural Setup Power Supply Check, Window Frame Preparation, Insulation & Seal Check
• Mounting the AC Unit Positioning the AC, Securing the Unit, Angle Adjustment for Drainage
• Operational Testing First Run Test, Airflow & Cooling Check, Noise & Vibration Check
• User Orientation Usage Demonstration, Maintenance Tips, Troubleshooting Basics
• Additional Services Accessory Installation, Old AC Removal, Custom Modifications